49F010
| Model | 49F010 |
| Description | 1-Megabit 128K x 8 5-volt Only CMOS Flash Memory |
| PDF file | Total 10 pages (File size: 251K) |
| Chip Manufacturer | ATMEL |
Features
•
•
•
•
•
•
•
•
•
•
Single Voltage Operation
- 5V Read
- 5V Reprogramming
Fast Read Access Time - 45 ns
Internal Program Control and Timer
8K bytes Boot Block With Lockout
Fast Erase Cycle Time - 10 seconds
Byte By Byte Programming - 10
µs/Byte
Hardware Data Protection
DATA Polling For End Of Program Detection
Low Power Dissipation
- 30 mA Active Current
- 100
µA
CMOS Standby Current
Typical 10,000 Write Cycles
Description
The AT49F010/HF010 are 5-volt-only in-system programmable and erasable Flash
Memories. Their 1-megabit of memory is organized as 131,072 words by 8 bits. Manu-
factured with Atmel’s advanced nonvolatile CMOS technology, the devices offer ac-
cess times to 45 ns (HF version) with a power dissipation of just 165 mW over the
commercial temperature range. When the device is deselected, the CMOS standby
current is less than 100
µA.
To allow for simple in-system reprogrammability, the AT49F010/HF010 does not re-
quire high input voltages for programming. Five-volt-only commands determine the
read and programming operation of the device. Reading data out of the device is
similar to reading from an EPROM. Reprogramming the AT49F010/HF010 is per-
formed by erasing the entire 1 megabit of memory and then programming on a byte
by byte basis. The byte programming time is a fast 50
µs.
The end of a program cycle
can be optionally detected by the DATA polling feature. Once the end of a byte pro-
1-Megabit
(128K x 8)
5-volt Only
CMOS Flash
Memory
AT49F010
AT49HF010
AT49F010/HF010
Pin Configurations
Pin Name
A0 - A16
CE
OE
WE
Function
Addresses
Chip Enable
Output Enable
Write Enable
DIP Top View
(continued)
I/O0 - I/O7 Data Inputs/Outputs
NC
No Connect
PLCC Top View
TSOP Top View
Type 1
0852AX–5/97
