D1861C023
| Model | D1861C023 |
| Description | D1861C 10 Gbits/s 1310 nm DML Module (6 dBm) |
| PDF file | Total 6 pages (File size: 90K) |
| Chip Manufacturer | AGERE |
Preliminary Data Sheet
March 2001
D1861C 10 Gbits/s 1310 nm DML Module (6 dBm)
Description
The D1861C direct-modulated laser (DML) module is
a cost-effective solution for 10 Gbits/s digital trans-
mission up to 50 km using traditional intracity
SMF-28
†
single-mode fiber links. The 1310 nm wave-
length eliminates the need for concern about disper-
sion control over most installed intracity fiber plants.
The package contains a high-speed DFB laser chip,
thermoelectric cooler, thermistor, optical isolator, and
a rear-facet monitor photodiode, which allows for
external optical power control.
7
–
6
+
5
+
4
–
3
–
2
1
Features
TEC
ESD
PROTECTION
R
TH
10 kΩ @ 25 °C
s
Direct-modulated 1310 nm laser module character-
ized for use in 10 Gbits/s operations up to 50 km
Average optical output power, 4 mW minimum
Temperature stabilized with internal thermoelectric
cooler (TEC), enabling operation within a wide
temperature range of –5 °C to +80 °C
Hermetically sealed optics, isolator on TEC
MPD
RF
CHOKE
ISOLATOR
DFB
R
MATCH
45
Ω
s
s
RF CONNECTOR
1-1157(F)
s
s
s
s
Figure 1. D1861C DML Electrical Schematic
GPO*
RF connector
Single-mode fiber pigtail
High relaxation frequency at low bias
Pin Information
Table 1. Pin Descriptions
Pin No.
1
2
3
4
5
6
7
Description
Thermistor
Thermistor
Laser Cathode (–), dc Bias
1
MPD Anode, (Negative Bias MPD)
MPD Cathode
Thermoelectric Cooler (+)
2
Thermoelectric Cooler (–)
Applications
s
s
s
SONET/SDH low-cost metro applications
High-speed data communications
DWDM equipment drop-side applications
1. Laser anode is case ground mAp-p drive current.
2. A positive current into this pin cools the laser.
*
GPO
is a trademark of Gilbert Engineering Co., Inc.
†
SMF-28
is a trademark of Corning Incorporated.
