OAT1045F-V5-C-05
| Model | OAT1045F-V5-C-05 |
| Description | Transceiver, 1530nm Min, 1565nm Max, 10700Mbps(Tx), 10700Mbps(Rx), FC Connector |
| PDF file | Total 13 pages (File size: 334K) |
| Chip Manufacturer | OKI |
OC-192/STM-64 SERDES Transceiver module Specification; OAT1043/1045x-V5-z-yy
Document NO: QPS-0302-014
OKI Confidential
Rev. DRAFT 0.3
8. Precautions for handling
The circuits of these modules operate at very small signal. In order to avoid the degradation of the optical
sensitivity due to external noise, the bottom pattern of these modules on the PCB should be ground pattern with low
impedance.
Do not mount/pattern device/circuits which generate high frequency noise close to the module.
In order to operate the module stable against the power noise, install the power supply noise reduction circuits.
The impedance between the power and ground pattern of the power circuit should be as low as possible. The elements
around the module should be mounted close to the pins of the module.
If an optical power exceeding the absolute maximum ratings is fed to the module, the optical receiver may be damaged.
Set the optical input power appropriately when in use of these modules.
9. Laser Safety
All version of transceiver are Class 1 Laser products FDA complies with 21 CFR 1040.10 and 1040.11 requirements.
Also, all versions are Class 1 Laser products pre IEC 825-1.
10. Ordering Information
OAT1043x-V5-z-yy -[ ] / OAT1045x-V5-z-yy -[ ]
Note: In z = A, B, D, E, “ -[ ] ” is added when 150MHz is specified to be TxREFCLK frequency.
Table 9 Ordering Information
x
Optical connector
S SC
F FC
L LC
M MU
A
B
C
D
E
z
Bit rate(Gbps)
9.95
10.3
9.95/10.3/10.6/10.7
10.7
10.6
yy
Fiber length
10 1m
05 0.5m
-[ ]
TxREFCLK frequency
blank
600MHz
-L
150MHz
OKI Electric Industry Co., Ltd Optical Components Company
13
