Q2426D
Model | Q2426D |
Description | SELF CONTAINED E GSM/GPRS 900/1800 OR 850/1900 BI BAND MODULE |
PDF file | Total 81 pages (File size: 909K) |
Chip Manufacturer | ETC |
WM_PRJ_Q2400_PTS_002 - 002
24th January 2003
2.16.1 Reset sequence
To activate the « emergency » reset sequence, the ~RST signal has to be set to
low for 500µs minimum. As soon as the reset is complete, the AT interface
answers « OK » to the application
.
EXTERNAL RST
Min:500µs
Typ:2ms
Module READY
STATE OF THE MODULE
Module ON
AT answers “OK”
Module READY
I
BB+RF
<120mA
without loc update
RESET mode
I
BB+RF
=20 to
40mA
SIM and network dependent
Figure 14 : Reset sequence
2.17
External Interrupt (~INTR)
The WISMO Quik Q24x6 Series provides an external interrupt input (not
managed in the standard AT commands firmware). This input is very sensitive
and an interrupt is activated on high to low edge. If this signal is not used it
can be left open. If used this input has to be driven by an open collector or an
open drain.
This input is used for instance to power OFF automatically the module.
Pin description
Signal
~INTR
Pin number
16
I/O
I
I/O type
CMOS
Description
External Interrupt
Electrical characteristics
Parameter
V
IL
V
IH
Min
-0.5V
2.2V
Max
0.7V
3.0V
Unit
Volt
Volt
4
For this, the application has to send AT↵. If the application manages hardware flow control, the
AT command can be sent during the initialisation phase. Another solution is to use the +WIND
command to get an unsollicited status from the module.
Page :
44 / 81
confidential ©
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à
des tiers sans son autorisation préalable.