S101-0520015BB
| Model | S101-0520015BB |
| Description | DC-DC Regulated Power Supply Module, 2 Output, Hybrid, ROHS COMPLIANT-10 |
| PDF file | Total 6 pages (File size: 210K) |
| Chip Manufacturer | MURATA |
www.murata-ps.com
S101-084-S101-00
5.0v Input, 1.5 to 3.3v Output @ 7A
This product is not fuse protected. User is responsible for providing system pro-
tection. Consult factory for application information.
Specifications *
S101-05
INPUT SPECIFICATIONS
Input voltage range
External input capacitor
5.0V ± 10%
Minimum 200μF with adequate
ripple current rating
1.5V
1.8V
Measured at +Vin pin
See also note on pg 6 and chart on pg 4
OUTPUT SPECIFICATIONS
Standard setpoint accuracy varies ±1.3%.
Contact factory for tighter tolerances. See
note on pg 5 for trimming to different volt-
ages.
100 LFM at 70°C
0 to 7A load
Over specified input voltage range
See also note on pg 6
Standard output voltages and
output current
2.1V
2.5V
3.3V
FEATURES
Output Current up to 7A
5.0V ± 10% input
Regulation ±0.4% Line and Load
Industry Standard Pin Configuration
High Efficiency To 90%
Remote Sense, Trim and Enable
Short Circuit Protection
MTBF 3.9 million hours
Output current
Load regulation
Line regulation
External output capacitor
Short circuit protection
7A
±0.4%
±0.4%
>150μF with maxESR = 100mΩ
200% of maximum rated current
GENERAL SPECIFICATIONS
Enable ***
Efficiency
Isolation
Switching frequency
Approvals and Standards
Protection
Operating Temperature ****
Storage Temperature
MTBF
ON - open or high / OFF - low
90% for 3.3V
Non-isolated
300 kHz
UL 94V-0
Fusing
0°C to 60°C
-40°C to 125°C
4.1 million hours
Non-condensing
Per RAC PRISM at 50°C ambient and 200 LFM
Unit is not fused.
Constant
See efficiency curves on pg 4
* All specifications are typical at nominal input, full load at 25°C unless otherwise stated.
*** Pull below 0.5V and sink greater than 1mA to disable the SIP; pull above 4V (do not exceed 12V) and source greater than 10μA or
leave
open to enable the SIP.
**** The output capacitors must meet the max ESR = 100mΩ requirement over the operating temperature range.
For full details go to
www.murata-ps.com/rohs
www.murata-ps.com
email: sales@murata-ps.com
29 Apr 2010 MDC_S101-084-S101-00.B01
Page 1 of 6
