U.FL-2LP-066-A-(500)
| Model | U.FL-2LP-066-A-(500) |
| Description | Interconnection Device |
| PDF file | Total 6 pages (File size: 222K) |
| Chip Manufacturer | HRS |
s
Product specifications
Ratings
Nominal characteristic impedance
Rated voltage
Rated frequency
50
ø
60 V AC (rms)
DC to 6 GHz
Operating temperature range
Operating humidity
-40˚C to +90˚C
90% max.
Item
1. Contact resistance
2. Insulation resistance
3. Withstand voltage
4. V.S.W.R.*
Dia.0.81Cable
Dia.1.13Cable
Dia.1.32Cable
5. Female contact holding force 0.15 N min.
6. Repetitive operation
Contact resistance
Specification
Center: 20 m
ø
max.
Outside: 10 m
ø
max.
500 M
ø
min.
No line or insulation breakdown
1.3 max.
1.35
1.4
1.5
3 to 6 GHz
Conditions
Measured at 10 mA max.
Measured at 100 V DC
200 V AC for 1 minute
DC to 3 GHz
Measured with a
Ø
0.475 pin gauge
25 m
ø
max. (Center)
15 m
ø
max. (Outside)
30 cycles of insertion and disengagement
Frequency of 10 to 100 Hz, single amplitude of 1.5 mm,
acceleration of 59 m/s
2
, for 5 cyles in the direction of each of the 3 axes
Acceleration of 735 m/s
2
, 11 ms duration, sine half-wave
waveform, for 6 cycles in the direction of each of the 3 axes
Temperature of 40˚C, humidity of 95%,
let stand for 96 hours
Temperature: +40˚C
/
5 to 35˚C
/
+90˚C
/
5 to 35˚C
Time:
30 min.
/
Within 5 min.
/
30 min.
/
Within 5 min.
Cycles: 5
48 hours continuous exposure to 5% salt water
7. Vibration
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness min.
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness
No damage, cracks, or parts looseness
Insulation resistance 100 M
ø
min.(High temperature)
Insulation resistance 500 M
ø
min.(Pry)
No damage, cracks, or parts looseness
Contact resistance 25 m
ø
max. (Center)
15 m
ø
max. (Outside)
No excessive corrosion
8. Shock
9. Humidity resistance
9.
(Steady state)
10. Temperature cycle
11. Salt spray test
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement system of the diagram below.
NOTE 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100cm cable.
NOTE 2: Board type connectors were mounted to a 50Ω glass epoxy board and
measurements were conducted with SMA conversion adapters attached.
sMaterials
Part
Shell
Male center contact
Female center contact
Insulator
Plug
Receptacle
Material
Phosphor bronze
Brass
Phosphor bronze
PBT
LCP
Finish
Silver plating
Gold plating
Gold plating
Black
Beige
Remarks
—————
—————
—————
UL94V-0
UL94V-0
2
