VSC7123RD
| Model | VSC7123RD |
| Description | 10-Bit Transceiver for Fibre Channel and Gigabit Ethernet |
| PDF file | Total 18 pages (File size: 210K) |
| Chip Manufacturer | VITESSE |
V
E
Y
C IT
LO
TM
VITESSE
SEMICONDUCTOR CORPORATION
Data Sheet
VSC7123
Features
• 802.3z Gigabit Ethernet-Compliant
1.25 Gb/s Transceiver
• ANSI X3T11 Fibre Channel-Compliant
1.0625 Gb/s Transceiver
• 0.98 to 1.36 Gb/s Full-Duplex Operation
• 10-Bit TTL Interface for Transmit and
Receive Data
10-Bit Transceiver for Fibre
Channel and Gigabit Ethernet
• Automatic Lock-to-Reference
• RX Cable Equalization
• Analog/Digital Signal Detection
• JTAG Access Port for Testability
• Single +3.3V Supply, 650mW Typical
• Packages: 64-Pin 10mm and 14mm PQFP and
10mm TQFP
General Description
The VSC7123 is a full-speed Fibre Channel and Gigabit Ethernet Transceiver with industry-standard
pinouts. The VSC7123 accepts 10-bit 8B/10B encoded transmit data, latches it on the rising edge of REFCLK
and serializes the data onto the TX PECL differential outputs at a baud rate which is 10 times the REFCLK
frequency. Serial data input on the RX PECL differential inputs is resampled by the Clock Recovery Unit
(CRU) and deserialized onto the 10-bit receive data bus synchronously to complementary divide-by-twenty
clocks. The VSC7123 receiver detects “Comma” characters for frame alignment. An analog/digital signal
detection circuit indicates that a valid signal is present on the RX input. A cable equalizer compensates for
InterSymbol Interference (ISI) in order to increase maximum cable distances. The VSC7123 is a higher
performance, lower cost replacement for the VSC7125 and VSC7135.
VSC7123 Block Diagram
10
R(0:9)
QD
Serial to
Q Parallel D
÷10
QD
2:1
RX+
RX-
RCLK
RCLKN
COMDET
ENCDET
EWRAP
SIGDET
T(0:9)
10
Clock
Recovery
÷20
Comma
Detect
Signal
Detect
Parallel
to Serial
DQ
DQ
TX+
TX-
REFCLK
x10 Clock
Multiply
NOT SHOWN: JTAG Boundary Scan
G52212-0, Rev 4.3
03/25//01
©
VITESSE
SEMICONDUCTOR CORPORATION
• 741 Calle Plano • Camarillo, CA 93012
Tel: (800) VITESSE • FAX: (805) 987-5896 • Email: prodinfo@vitesse.com
Internet: www.vitesse.com
Page 1
