W49V002AQ
| Model | W49V002AQ |
| Description | 256K x 8 CMOS FLASH MEMORY WITH LPC INTERFACE |
| PDF file | Total 32 pages (File size: 281K) |
| Chip Manufacturer | WINBOND |
Preliminary W49V002A
256K x 8 CMOS FLASH MEMORY
WITH LPC INTERFACE
GENERAL DESCRIPTION
The W49V002A is a 2
-megabit, 3.3-volt only CMOS flash memory organized as 256K
×
8 bits. The
device can be programmed and erased in-system with a standard 3.3V power supply. A 12-volt V
PP
is
not required. The unique cell architecture of the W49V002A results in fast program/erase operations with
extremely low current consumption. This device can operate at two modes, Programmer bus interface
mode and LPC bus interface mode. As in the Programmer interface mode, it acts like the traditional
flash but with a multiplexed address inputs. But in the LPC interface mode, this device complies with the
Intel LPC specification 1.0. The device can also be programmed and erased using standard EPROM
programmers.
FEATURES
•
Single 3.3-volt operations:
bytes, 64K bytes, 64K bytes each)
•
Low power consumption
−
3.3-volt Read
−
3.3-volt Erase
−
3.3-volt Program
•
Fast Program operation:
−
Active current: 25 mA (typ.)
−
Standby current: 20
µA
(typ.)
•
Automatic program and erase timing with
internal V
PP
generation
•
End of program or erase detection
−
Byte-by-Byte programming: 50
µS
(typ.)
•
Fast Erase operation: 150 mS (typ.)
•
Endurance: 10K cycles (typ.)
•
Twenty-year data retention
•
Hardware data protection
−
Toggle bit
−
Data polling
•
Latched address and data
•
TTL compatible I/O
•
Available packages: 32L PLCC and 32L
−
#TBL & #WP serve as hardware protection
•
One 16K bytes Boot Block with lockout
protection
•
Two 8K bytes Parameter Blocks
•
Four Main Memory Blocks (with 32K bytes, 64K
STSOP
-1 -
Publication Release Date: April 2001
Revision A1
