X1227V8I-2.7
| Model | X1227V8I-2.7 |
| Description | Real Time Clock/Calendar/CPU Supervisor with EEPROM |
| PDF file | Total 28 pages (File size: 443K) |
| Chip Manufacturer | XICOR |
X1227
Notes:
(1) The device enters the Active state after any start, and remains active: for 9 clock cycles if the Device Select Bits in the Slave
Address Byte are incorrect or until 200nS after a stop ending a read or write operation.
(2) The device enters the Program state 200nS after a stop ending a write operation and continues for t
WC
.
(3) The device goes into the Timekeeping state 200nS after any stop, except those that initiate a nonvolatile write cycle; t
WC
after a
stop that initiates a nonvolatile write cycle; or 9 clock cycles after any start that is not followed by the correct Device Select Bits in
the Slave Address Byte.
(4) For reference only and not tested.
(5) V
IL
= V
CC
x 0.1, V
IH
= V
CC
x 0.9, f
SCL
= 400KHz
(6) V
CC
= 0V
(7) V
BACK
= 0V
(8) V
SDA
= V
SCL
=V
CC
, Others = GND or V
CC
(9) V
SDA
=V
SCL
=V
BACK
, Others = GND or V
BACK
(10) V
SDA
= GND or V
CC
, V
SCL
= GND or V
CC
, V
RESET
= GND or V
CC
(11) I
OL
= 3.0mA at 5.5V, 1.5mA at 2.7V
(12) I
OH
= -1.0mA at 5.5V, -0.4mA at 2.7V
(13) Threshold voltages based on the higher of Vcc or Vback.
(14) Using recommended crystal and oscillator network applied to X1 and X2 (25°C).
(15) Typical values are for T
A
= 25°C
Capacitance
T
A
= 25°C, f = 1.0 MHz, V
CC
= 5V
Symbol
C
OUT
(1)
C
IN
(1)
Parameter
Output Capacitance (SDA, RESET)
Input Capacitance (SCL)
Max.
10
10
Units
pF
pF
Test Conditions
V
OUT
= 0V
V
IN
= 0V
Notes:
(1) This parameter is not 100% tested.
(2) The input capacitance between x1 and x2 pins can be varied between 5pF and 19.75pF by using analog trimming registers
AC CHARACTERISTICS
AC Test Conditions
Input Pulse Levels
Input Rise and Fall Times
Input and Output Timing
Levels
Output Load
V
CC
x 0.1 to V
CC
x 0.9
10ns
V
CC
x 0.5
Standard Output Load
Figure 18. Standard Output Load for testing the device with V
CC
= 5.0V
Equivalent AC Output Load Circuit for V
CC
= 5V
5.0V
1533Ω
SDA
100pF
For V
OL
= 0.4V
and I
OL
= 3 mA
REV 1.1.20 1/13/03
www.xicor.com
Characteristics subject to change without notice.
17 of 28
Related PDFs
| Model | Description | Manufacturer | Operation |
|---|---|---|---|
 X1227V8I-2.7
|
2-Wire RTC Real TimeClock/Calendar/CPU Supervisor with EEPROM | INTERSIL | Preview |
|
X1227V8I-2.7A
|
2-Wire RTC Real TimeClock/Calendar/CPU Supervisor with EEPROM | INTERSIL | Preview |
|
X1227V8I-2.7A
|
Real Time Clock/Calendar/CPU Supervisor with EEPROM | XICOR | Preview |
