C01630C00610012
| Model | C01630C00610012 |
| Description | Circular Connector |
| PDF file | Total 20 pages (File size: 2M) |
| Chip Manufacturer | AMPHENOL |
Technical Information
Crimp Termination
A crimp connection is a non-detachable electrical connection between a
wire and a crimp contact produced with the crimp technology.
Precise crimping dies which are matched to the crimp barrel and the
wire size and a defined deformation result in a reliable electrical
connection.
There are open crimp barrels (stamped contacts) and closed crimp
barrels (turned contacts).
The main advantages of crimp connections are:
• Efficient termination of contacts
• Reproducible terminations achieve consistent
electrical and mechanical results
The requirements for crimp connections are defined
in IEC 60352 Part 2 / DIN EN 60352 Part 2.
An important point of the quality of a crimp connection is the achieved
tensile strength of the termination.
Easily measured, the tensile strength is a practible means for quality
control purposes.
Diagram 2 below shows the required minimum tensile strength for open
and closed barrels depending on the wire size.
Assembly instructions
For crimp contacts use the released crimp tool.
The insertion and extraction of crimp contacts shall only be approved with
the corresponding insertion/extraction tool.
A detailed description of the crimp technology can be found in
our crimp tooling catalogues.
Crimp contacts are in this catalogue on page 10.
Diagram 2
N
1000
lb
4000
3000
500
400
300
2000
1000
200
Min. tensile strength N
100
500
400
300
50
40
30
20
200
100
10
50
40
30
5
mm
2
0,05
AWG
0,1
0,2
28
26
24
22
0,5
20
1,0 1,5
2,5
4,0 6,0
12
10
14
18 16
10,0
8
20
Wire gauge in mm
2
/ AWG
14
Min. tensile strength lb
Amphenol
