N010-0550-T601
| Model | N010-0550-T601 |
| Description | Resistive Touch Panel Specification |
| PDF file | Total 7 pages (File size: 322K) |
| Chip Manufacturer | FUJITSU |
FID-550 SERIES
s
9.0 CONNECTION AND MOUNTING
The details below indicate the recommended mounting structure for panel and enclosure. The enclosure
support to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area).
Also ensure that the enclosure does not cause miss input by touching the view area.
The following diagram shows that the enclosure edge must be between the View area and the guaranteed
active area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel
and enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch
panel are conductive so do not touch any metal parts after mounting.
Top View (Picture, with conductive
side down)
Location
1.
2.
3.
4.
5.
6.
7.
Right/ Upper
Right/ Upper
Each side
Left/ Lower
Each side
Left/ Lower
All
Film
Detect
Glass
Glass
Glass
Glass
Glass
Glass
0.7
3.35
2.0
Stiffener Board
1.2
1.1
2.0
Conductive Face
FPC-type cable
Laminate Film
Contact Section View
Bottom View (Drawing, with conductive side up)
(Mating connector type FCI or equivalent SFW15R-1ST: for FPC)
Transparent Area
Anit-input Area
0.8 mm min.
Input Area
Shock absorber to protect
the panel (eg rubber)
Input Panel
0.3 to 0.1 mm
View Area
LCD
Shock absorber
for protection
Connector
Circuit Board
Upper Case
Cut-out / avoidance of
550 surface mount diodes
Wiring Area
0.3±0.05
6
