0011152
Model | 0011152 |
Description | Connector Accessory, Junction Block, Thermoplastic, |
PDF file | Total 108 pages (File size: 14M) |
Chip Manufacturer | AMPHENOL |
insertion du contact
L’insertion des contacts s’effectue avec l’outil côté COULEUR qui cor-
respond à la taille des contacts.
❶ Tenir l’outil et insérer le câble dans la gorge longitudinale de l’outil.
❷ Tirer le fil vers l’arrière à travers l’outil jusqu’à ce que l’extrémité
de l’outil repose sur l’épaulement de la collerette du contact.
❶
contact insertion
The contact insertion is made with the tool COLOUR side, the tool
depending on the contact size.
❶ Hold the tool and insert the cable into the longitudinal groove.
❷ Pull the cable to the rear of the tool until the end of the tool is in
contact with the contact flange.
❷
Côté couleur
Colour side
❸ Présenter le contact dans la cavité choisie pour le raccordement.
❹ Pousser lentement le contact dans la cavité du module à l’aide de
l’outil. Une butée franche sera rencontrée lorsque le contact aura pris
sa place dans la cavité.
❺ Relâcher le câble et retirer l’outil. Effectuer une légère traction
sur le câble pour être sûr que le contact est correctement verrouillé.
❸ Place the contact in the cavity of the module.
❹ With the tool, slowly push the contact in the cavity. You will feel a
clear stop once the contact is in position in the cavity.
❺ Release the cable and pull out the tool. Proceed to a gentle pull on
the cable to ensure that the contact is properly locked in.
❸
❹
❺
eXtraction du contact
L’extraction des contacts s’effectue avec l’outil côté BLANC qui cor-
respond à la taille des contacts.
❶ Placer le câble du contact à démonter dans la gorge longitudinale
de l’outil.
❷ Glisser lentement l’outil le long du câble dans la cavité jusqu’à ce
qu’il rencontre une butée mécanique. A cet instant, les clips de réten-
tion du contact se trouvent déverrouillés.
❸ Comprimer le câble du contact à démonter contre les stries de
l’outil et tirer simultanément, sans tourner, le câble et l’outil hors de
la cavité du module.
contact eXtraction
instructions / procédures
The contact extraction is made with the tool WHITE side, the tool
depending on the contact size.
❶ Put the contact cable to be extracted in the longitudinal groove
of the tool.
❷ Gently slide the tool down along the cable in the cavity until a
mechanical stop is reached. At this point, the contact retention clip
is unlocked.
❸ Press the cable to be extracted against the grooves of the tool and
pull straight out. The contact is extracted.
❶
❷
❸
AMPHENOL AIR LB - 2 rue Clément Ader, Zac de Wé - 08110 CARIGNAN - FRANCE
Tel. : +33 (0)3 24 22 78 49 - Fax : +33 (0)3 24 22 78 75 - www.amphenol-airlb.fr
87