B1160C
| Model | B1160C |
| Description | solid state crowbar devices |
| PDF file | Total 212 pages (File size: 2M) |
| Chip Manufacturer | TECCOR |
CATV Line Amplifiers/Power Inserters SIDACtor Device
CATV Line Amplifiers/Power Inserters
SIDACtor
Device
1
2
This
SIDACtor
device is a 5000 A solid state protection device offered in a non-isolated
TO-218 package. It protects equipment located in the severe surge environment of CATV
(Community Antenna TV) applications.
In CATV line amplifiers and power inserters, this device can replace the gas tubes
traditionally used for station protection because
SIDACtor
devices have much tighter
voltage tolerances.
Electrical Parameters
Part
Number *
P1900ME
P2300ME
V
DRM
Volts
140
180
V
S
Volts
220
260
V
T
Volts
4
4
I
DRM
µAmps
5
5
I
S
mAmps
800
800
I
T
Amps **
2.2/25
2.2/25
I
H
mAmps
50
50
C
O
pF
750
750
* For surge ratings, see table below.
** I
T
is a free air rating; heat sink I
T
rating is 25 A.
General Notes:
• All measurements are made at an ambient temperature of 25 °C. I
PP
applies to -40 °C through +85 °C temperature range.
• I
PP
is a repetitive surge rating and is guaranteed for the life of the product.
• Listed
SIDACtor
devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
• V
DRM
is measured at I
DRM.
• V
S
is measured at 100 V/µs.
• Special voltage (V
S
and V
DRM
) and holding current (I
H
) requirements are available upon request.
• Off-state capacitance is measured at 1 MHz with a 2 V bias and is a typical value.
Surge Ratings
I
PP
8x20 µs
Amps
5000
I
TSM
60 Hz
Amps
400
di/dt
Amps/µs
500
Series
E
http://www.teccor.com
+1 972-580-7777
2 - 64
SIDACtor
®
© 2002 Teccor Electronics
Data Book and Design Guide
