I1K-L67132L-45
| Model | I1K-L67132L-45 |
| Description | Dual-Port SRAM, 2KX8, 45ns, CMOS, CDIP48, 0.600 INCH, CERAMIC, DIP-48 |
| PDF file | Total 14 pages (File size: 178K) |
| Chip Manufacturer | TEMIC |
L67132/L67142
Timing Waveform of Write Cycle n
o
1, R/W Controlled Timing
(32, 33, 34, 38)
Timing Waveform of Write Cycle n
o
2, CS Controlled Timing
(32, 33, 34, 36)
Notes :
R/W must be high during all address transitions.
A write occurs during the overlap (t
SW
or t
WP
) of a low CS and a low R/W.
t
WR
is measured from the earlier of CS or R/W going high to the end of write cycle.
During this period, the I/O pins are in the output state, and input signals must not be applied.
If the CS low transition occurs simultaneously with or after the R/W low transition, the outputs remain in the high
impedance state.
37. Transition is measured
±
500 mV from steady state with a 5 pF load (including scope and jig). This parameter is sampled
and not 100 % tested.
38. If OE is low during a R/W controlled write cycle, the write pulse width must be the larger of t
WP
or (t
WZ
+ t
DW
)
to allow the I/O drivers to turn off and data to be placed on the bus for the required t
DW
. If OE is high during an R/W
controlled write cycle, this requirement does not apply and the write pulse can be as short as the specified t
WP
.
39. To access RAM, CS = VIL.
32.
33.
34.
35.
36.
MATRA MHS
Rev. D (19 Fev. 97)
9
