TC1303C-1A1EMF
| Model | TC1303C-1A1EMF |
| Description | 0.5 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, PDSO10, 3 X 3 MM, 0.9 MM HEIGHT, PLASTIC, DFN-10 |
| PDF file | Total 38 pages (File size: 756K) |
| Chip Manufacturer | MICROCHIP |
TC1303A/TC1303B/TC1303C/TC1304
4.4
Power-Good
4.5
Power Good Output Options
A Power-Good (PG) output signal is generated based
off of the buck regulator output voltage (V
OUT1
), the
LDO output voltage (V
OUT2
) or the combination of both
outputs. A fixed delay time of approximately 262 ms is
generated once the monitored output voltage is above
the power-good threshold (typically 94% of V
OUTX
). As
the monitored output voltage falls out of regulation, the
falling PG threshold is typically 92% of the output
voltage. The PG output signal is pulled up to the output
voltage, indicating that power is good and pulled low,
indicating that the output is out of regulation. The
typical quiescent current draw for power-good circuitry
is less than 10 µA.
If the monitored output voltage falls below the power-
good threshold, the power-good output will transition to
the Low state. The power-good circuitry has a 165 µs
delay when detecting a falling output voltage. This
helps to increase the noise immunity of the power-good
output, avoiding false triggering of the PG signal during
line and load transients.
There are three monitoring options for the TC1303
family.
For the TC1303A, only the buck regulator output
voltage (V
OUT1
) is monitored. The PG output signal
depends only on V
OUT1
.
For the TC1303B, only the LDO output voltage (V
OUT2
)
is monitored. The PG output signal depends only on
V
OUT2
.
For the TC1303C and TC1304, both the buck regulator
output voltage and LDO output voltage are monitored.
If either one of the outputs fall out of regulation, the PG
will be low. Only if both V
OUT1
and V
OUT2
are within the
PG voltage threshold limits will the PG output be high.
For the TC1303A,C and TC1304, the PG output pin is
open drain and can be pulled up to any level within the
given absolute maximum ratings (A
GND
- 0.3V) to (V
IN
+ 0.3V).
TABLE 4-1:
Part
Number
PG AVAILABLE OPTIONS
PG Output
Buck
(V
OUT1
)
Yes
No
Yes
Yes
PG
Output
LDO
(V
OUT2
)
No
Yes
Yes
Yes
PG Output
Type
Open-Drain
Push-Pull
(V
OUT2
)
Open-Drain
Open-Drain
V
TH_H
V
OUT1
or V
OUT2
t
RPU
V
OH
TC1303A
TC1303B
t
RPD
TC1303C
TC1304
PG
V
OL
FIGURE 4-1:
Power-Good Timing.
DS21949C-page 22
©
2008 Microchip Technology Inc.
