T1022NXE7MQA
| Model | T1022NXE7MQA |
| Description | 32-BIT, 1200MHz, RISC PROCESSOR, PBGA780 |
| PDF file | Total 197 pages (File size: 1M) |
| Chip Manufacturer | PHILIPS |
Electrical characteristics
Table 89. MPIC DC electrical characteristics (DV
DD
= 3.3 V)
3
Parameter
Input high voltage
Input low voltage
Input current (DV
IN
= 0 V or DV
IN
= DV
DD
)
Output high voltage (DV
DD
= min, I
OH
= -2 mA)
Output low voltage (DV
DD
= min, I
OL
= 2 mA)
Note:
1. The min V
IL
and max V
IH
values are based on the min and max DV
IN
respective values found in
2. The symbol DV
IN
, in this case, represents the DV
IN
symbol referenced in
3. For recommended operating conditions, see
4. DVDD should be replaced by the respective IO power supply i.e. L1VDD, DVDD or CVDD.
Symbol
V
IH
V
IL
I
IN
V
OH
V
OL
-
-
2.4
-
Min
0.7 * DVDD
-
0.2 * DVDD
±40
-
0.4
Max
V
V
µA
V
V
Unit
Notes
1, 4
1, 4
2
-
-
3.16.2 MPIC AC timing specifications
This table provides the MPIC input and output AC timing specifications.
Table 90. MPIC Input AC timing specifications
2
Characteristic
MPIC inputs-minimum pulse width
Symbol
t
PIWID
3
Min
-
Max
Unit
SYSCLKs
Notes
1, 3
1. MPIC inputs and outputs are asynchronous to any visible clock. MPIC outputs must be synchronized before use by any
external synchronous logic. MPIC inputs are required to be valid for at least t
PIWID
ns to ensure proper operation when
working in edge triggered mode.
2. For recommended operating conditions, see
3. Entry and exit from deep sleep respectively require a minimum pulse width t
PIWID
of 25 SYSCLK. See the Reference
Manual for details on Entry and Exit from deep sleep.
3.17 JTAG controller
This section describes the DC and AC electrical specifications for the IEEE 1149.1
(JTAG) interface.
3.17.1 JTAG DC electrical characteristics
This table provides the JTAG DC electrical characteristics.
QorIQ T1042, T1022 Data Sheet, Rev. 2, 06/2015
124
Freescale Semiconductor, Inc.
