U1AFS250-2FGG256YI
| Model | U1AFS250-2FGG256YI |
| Description | FPGA |
| PDF file | Total 334 pages (File size: 18M) |
| Chip Manufacturer | MICROSEMI |
Fusion Family of Mixed Signal FPGAs
Revision
Advance v0.6
(continued)
Changes
The
"Voltage Monitor" section
was updated to include information about low power
mode and sleep mode.
The text in the
"Current Monitor" section
was changed from 2 mV to 1 mV.
The
"Gate Driver" section
was updated to include information about forcing 1 V on
the drain.
The
"Analog-to-Digital Converter Block" section
was updated with the following
statement:
"All results are MSB justified in the ADC."
The information about the ADCSTART signal was updated in the
"ADC Description"
section.
Table 2-46 · Analog Channel Specifications
was updated.
Table 2-47 · ADC Characteristics in Direct Input Mode
was updated.
Table 2-51 • ACM Address Decode Table for Analog Quad
was updated.
In
Table 2-53 • Analog Quad ACM Byte Assignment,
the Function and Default
Setting for Bit 6 in Byte 3 was updated.
The
"Introduction" section
was updated to include information about digital inputs,
outputs, and bibufs.
In
Table 2-69 • Fusion Pro I/O Features,
the programmable delay descriptions were
updated for the following features:
Single-ended receiver
Voltage-referenced differential receiver
LVDS/LVPECL differential receiver features
The
"User I/O Naming Convention" section
was updated to include "V" and "z"
descriptions
The
"VCC33PMP Analog Power Supply (3.3 V)" section
was updated to include
information about avoiding high current draw.
The
"VCCNVM Flash Memory Block Power Supply (1.5 V)" section
was updated to
include information about avoiding high current draw.
The
"VMVx I/O Supply Voltage (quiet)" section
was updated to include this
statement: VMV and VCCI must be connected to the same power supply and V
CCI
pins within a given I/O bank.
The
"PUB Push Button" section
was updated to include information about leaving
the pin floating if it is not used.
The
"PTBASE Pass Transistor Base" section
was updated to include information
about leaving the pin floating if it is not used.
The
"PTEM Pass Transistor Emitter" section
was updated to include information
about leaving the pin floating if it is not used.
The heading was incorrect in the
"208-Pin PQFP" table.
It should be AFS250 and not
AFS090.
Page
2-86
2-90
2-94
2-99
2-102
2-118
2-121
2-127
2-130
2-133
2-137
2-159
2-224
2-224
2-185
2-228
2-228
2-228
3-8
Revision 3
5- 13
