U1AFS600-2FG484
| Model | U1AFS600-2FG484 |
| Description | Field Programmable Gate Array, |
| PDF file | Total 334 pages (File size: 18M) |
| Chip Manufacturer | MICROSEMI |
Datasheet Information
Revision
Advance 1.0
(continued)
Changes
In the
"Gate Driver" section,
25 mA was changed to 20 mA and 1.5 MHz was
changed to 1.3 MHz. In addition, the following sentence was deleted:
The maximum AG pad switching frequency is 1.25 MHz.
The
"Temperature Monitor" section
was updated to rewrite most of the text and add
Figure 2-78, Figure 2-79,
and
Table 2-38 • Temperature Data Format.
In
Table 2-38 • Temperature Data Format,
the temperature K column was changed
for 85°C from 538 to 358.
In
Table 2-45 • ADC Interface Timing,
"Typical-Case" was changed to "Worst-Case."
The
"ADC Interface Timing" section
is new.
Table 2-46 • Analog Channel Specifications
was updated.
The
"V
CC15A
Analog Power Supply (1.5 V)" section
was updated.
The
"V
CCPLA/B
PLL Supply Voltage" section
is new.
In
"V
CCNVM
Flash Memory Block Power Supply (1.5 V)" section,
supply was
changed to supply input.
The
"V
CCPLA/B
PLL Supply Voltage"
pin description was updated to include the
following statement:
Actel recommends tying VCCPLX to VCC and using proper filtering circuits to
decouple V
CC
noise from PLL.
The
"V
COMPLA/B
Ground for West and East PLL" section
was updated.
In
Table 2-47 • ADC Characteristics in Direct Input Mode,
the commercial conditions
were updated and note 2 is new.
The V
CC33ACAP
signal name was changed to
"XTAL1 Crystal Oscillator Circuit
Input".
Table 2-48 • Uncalibrated Analog Channel Accuracy*
is new.
Table 2-49 • Calibrated Analog Channel Accuracy
1,2,3
is new.
Table 2-50 • Analog Channel Accuracy: Monitoring Standard Positive Voltages
is
new.
In
Table 2-57 • Voltage Polarity Control Truth Table—AV (x = 0), AC (x = 1), and AT
(x = 3)*,
the following I/O Bank names were changed:
Hot-Swap changed to Standard
LVDS changed to Advanced
In
Table 2-58 • Prescaler Op Amp Power-Down Truth Table—AV (x = 0), AC (x = 1),
and AT (x = 3),
the following I/O Bank names were changed:
Hot-Swap changed to Standard
LVDS changed to Advanced
In the title of
Table 2-64 • I/O Standards Supported by Bank Type,
LVDS I/O was
changed to Advanced I/O.
The title was changed from "Fusion Standard, LVDS, and Standard plus Hot-Swap
I/O" to
Table 2-68 • Fusion Standard and Advanced I/O Features.
In addition, the
table headings were all updated. The heading used to be Standard and LVDS I/O
and was changed to Advanced I/O. Standard Hot-Swap was changed to just
Standard.
Page
2-94
2-96
2-98
2-110
2-110
2-118
2-224
2-225
2-224
2-225
2-225
2-121
2-228
2-123
2-124
2-125
2-131
2-132
2-134
2-136
5-8
R e vi s i o n 2
Related PDFs
| Model | Description | Manufacturer | Operation |
|---|---|---|---|
 U1AFS600-2FG484YC
|
FPGA | MICROSEMI | Preview |
