MC9S12XDP512CFU
| Model | MC9S12XDP512CFU |
| Description | 16-BIT, FLASH, 40MHz, MICROCONTROLLER, PQFP80 |
| PDF file | Total 1348 pages (File size: 8M) |
| Chip Manufacturer | PHILIPS |
This register configures the output pins as wired-OR. If enabled the output is driven active low only
(open-drain). A logic level of “1” is not driven. It applies also to the SPI and SCI outputs and allows
a multipoint connection of several serial modules. These bits have no influence on pins used as
inputs.
Table 24-27. WOMS Field Descriptions
Field
7–0
Wired-OR Mode Port S
WOMS[7:0] 0 Output buffers operate as push-pull outputs.
1 Output buffers operate as open-drain outputs.
Description
24.0.5.26 Port M Data Register (PTM)
7
6
5
4
3
2
1
0
R
PTM7
W
CAN
Routed
CAN0
Routed
CAN4
Routed
SPI0
Reset
0
0
TXCAN4
RXCAN4
TXCAN0
TXCAN4
SCK0
0
RXCAN0
RXCAN4
MOSI0
0
SS0
0
MISO0
0
0
0
TXCAN0
RXCAN0
TXCAN0
RXCAN0
PTM6
PTM5
PTM4
PTM3
PTM2
PTM1
PTM0
Figure 24-28. Port M Data Register (PTM)
Read: Anytime.
Write: Anytime.
Port M pins 7–0 are associated with the CAN0, as well as the routed CAN0, CAN4, and SPI0
modules. When not used with any of the peripherals, these pins can be used as general purpose I/O.
If the data direction bits of the associated I/O pins are set to logic level “1”, a read returns the value
of the port register, otherwise the buffered pin input state is read.
Table 24-28. PTM Field Descriptions
Field
7–6
PTM[7:6]
5–4
PTM[5:4]
Description
The CAN4 function (TXCAN4 and RXCAN4) takes precedence over the general purpose I/O function if the CAN4
module is enabled.
Refer to MSCAN section for details.
The routed CAN0 function (TXCAN0 and RXCAN0) takes precedence over the routed CAN4, the routed SPI0
and the general purpose I/O function if the routed CAN0 module is enabled.
The routed CAN4 function (TXCAN4 and RXCAN4) takes precedence over the routed SPI0 and general purpose
I/O function if the routed CAN4 module is enabled.
Refer to MSCAN section for details.
The routed SPI0 function (SCK0 and MOSI0) takes precedence of the general purpose I/O function if the routed
SPI0 is enabled.
Refer to SPI section for details.
