S912XEG128J2VAL
| Model | S912XEG128J2VAL |
| Description | IC,MICROCONTROLLER,16-BIT,CPU12 CPU,CMOS,QFP,112PIN,PLASTIC |
| PDF file | Total 1327 pages (File size: 7M) |
| Chip Manufacturer | ROCHESTER |
Chapter 29 1024 KByte Flash Module (S12XFTM1024K5V2)
Table 29-70. Erase D-Flash Sector Command Error Handling
Because of an order from the United States International Trade Commission, BGA-packaged product lines and part numbers indicated here currently are not
available from Freescale for import or sale in the United States prior to September 2010: S12XE products in 208 MAPBGA packages
Register
Error Bit
Error Condition
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Table 29-30)
ACCERR
Set if an invalid global address [22:0] is supplied
FSTAT
FPVIOL
MGSTAT1
MGSTAT0
FERSTAT
EPVIOLIF
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the global address [22:0] points to the D-Flash EEE partition
None
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
None
29.4.2.19 Enable EEPROM Emulation Command
The Enable EEPROM Emulation command causes the Memory Controller to enable EEE activity. EEE
activity is disabled after any reset.
Table 29-71. Enable EEPROM Emulation Command FCCOB Requirements
CCOBIX[2:0]
000
0x13
FCCOB Parameters
Not required
Upon clearing CCIF to launch the Enable EEPROM Emulation command, the CCIF flag will set after the
Memory Controller enables EEE operations using the contents of the EEE tag RAM and tag counter. The
Full Partition D-Flash or the Partition D-Flash command must be run prior to launching the Enable
EEPROM Emulation command.
Table 29-72. Enable EEPROM Emulation Command Error Handling
Register
Error Bit
Error Condition
Set if CCOBIX[2:0] != 000 at command launch
ACCERR
FSTAT
FPVIOL
MGSTAT1
MGSTAT0
FERSTAT
EPVIOLIF
None
None
None
None
Set if a Load Data Field command sequence is currently active
Set if Full Partition D-Flash or Partition D-Flash command not previously run
MC9S12XE-Family Reference Manual Rev. 1.19
Freescale Semiconductor
1193
