S912XEG128J2VAL
| Model | S912XEG128J2VAL |
| Description | IC,MICROCONTROLLER,16-BIT,CPU12 CPU,CMOS,QFP,112PIN,PLASTIC |
| PDF file | Total 1327 pages (File size: 7M) |
| Chip Manufacturer | ROCHESTER |
Chapter 26 384 KByte Flash Module (S12XFTM384K2V1)
Table 26-50. Erase P-Flash Block Command Error Handling
Because of an order from the United States International Trade Commission, BGA-packaged product lines and part numbers indicated here currently are not
available from Freescale for import or sale in the United States prior to September 2010: S12XE products in 208 MAPBGA packages
Register
Error Bit
Error Condition
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
ACCERR
Set if command not available in current mode (see
Table 26-30)
FSTAT
FPVIOL
MGSTAT1
MGSTAT0
Set if an invalid global address [22:16] is supplied
(1)
Set if an area of the selected P-Flash block is protected
Set if any errors have been encountered during the verify operation
(2)
Set if any non-correctable errors have been encountered during the verify
operation
2
FERSTAT
EPVIOLIF
None
1. As defined by the memory map for FTM512K3.
2. As found in the memory map for FTM512K3.
26.4.2.10 Erase P-Flash Sector Command
The Erase P-Flash Sector operation will erase all addresses in a P-Flash sector.
Table 26-51. Erase P-Flash Sector Command FCCOB Requirements
CCOBIX[2:0]
000
001
0x0A
FCCOB Parameters
Global address [22:16] to identify
P-Flash block to be erased
Global address [15:0] anywhere within the sector to be erased.
Refer to
Section 26.1.2.1
for the P-Flash sector size.
Upon clearing CCIF to launch the Erase P-Flash Sector command, the Memory Controller will erase the
selected Flash sector and then verify that it is erased. The CCIF flag will be set after the Erase P-Flash
Sector operation has completed.
MC9S12XE-Family Reference Manual , Rev. 1.19
Freescale Semiconductor
997
