S912XEG128J2VAL
| Model | S912XEG128J2VAL |
| Description | IC,MICROCONTROLLER,16-BIT,CPU12 CPU,CMOS,QFP,112PIN,PLASTIC |
| PDF file | Total 1327 pages (File size: 7M) |
| Chip Manufacturer | ROCHESTER |
Chapter 6 Interrupt (S12XINTV2)
6.1.1
Glossary
Table 6-2. Terminology
Term
CCR
DMA
INT
IPL
ISR
MCU
XGATE
IRQ
XIRQ
Direct Memory Access
Interrupt
Interrupt Processing Level
Interrupt Service Routine
Micro-Controller Unit
refers to the XGATE co-processor; XGATE is an optional feature
refers to the interrupt request associated with the IRQ pin
refers to the interrupt request associated with the XIRQ pin
Because of an order from the United States International Trade Commission, BGA-packaged product lines and part numbers indicated here currently are not
available from Freescale for import or sale in the United States prior to September 2010: S12XE products in 208 MAPBGA packages
The following terms and abbreviations are used in the document.
Meaning
Condition Code Register (in the S12X CPU)
6.1.2
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Features
Interrupt vector base register (IVBR)
One spurious interrupt vector (at address vector base
1
+ 0x0010).
One non-maskable system call interrupt vector request (at address vector base + 0x0012).
Three non-maskable access violation interrupt vector requests (at address vector base + 0x0014−
0x0018).
2–109 I bit maskable interrupt vector requests (at addresses vector base + 0x001A–0x00F2).
Each I bit maskable interrupt request has a configurable priority level and can be configured to be
handled by either the CPU or the XGATE module
2
.
I bit maskable interrupts can be nested, depending on their priority levels.
One X bit maskable interrupt vector request (at address vector base + 0x00F4).
One non-maskable software interrupt request (SWI) or background debug mode vector request (at
address vector base + 0x00F6).
One non-maskable unimplemented op-code trap (TRAP) vector (at address vector base + 0x00F8).
Three system reset vectors (at addresses 0xFFFA–0xFFFE).
Determines the highest priority XGATE and interrupt vector requests, drives the vector to the
XGATE module or to the bus on CPU request, respectively.
Wakes up the system from stop or wait mode when an appropriate interrupt request occurs or
whenever XIRQ is asserted, even if X interrupt is masked.
XGATE can wake up and execute code, even with the CPU remaining in stop or wait mode.
1. The vector base is a 16-bit address which is accumulated from the contents of the interrupt vector base register (IVBR, used
as upper byte) and 0x00 (used as lower byte).
2. The IRQ interrupt can only be handled by the CPU
MC9S12XE-Family Reference Manual , Rev. 1.19
262
Freescale Semiconductor
