S912XEG128J2VAL
| Model | S912XEG128J2VAL |
| Description | IC,MICROCONTROLLER,16-BIT,CPU12 CPU,CMOS,QFP,112PIN,PLASTIC |
| PDF file | Total 1327 pages (File size: 7M) |
| Chip Manufacturer | ROCHESTER |
Chapter 25 256 KByte Flash Module (S12XFTM256K2V1)
state. During the execution of this command (CCIF=0) the user must not write to any Flash module
register. The CCIF flag is set after the Unsecure Flash operation has completed.
Table 25-54. Unsecure Flash Command Error Handling
Register
Error Bit
Error Condition
Set if CCOBIX[2:0] != 000 at command launch
ACCERR
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Table 25-30)
FSTAT
FPVIOL
MGSTAT1
MGSTAT0
FERSTAT
EPVIOLIF
Set if any area of the P-Flash memory is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Set if any area of the buffer RAM EEE partition is protected
Because of an order from the United States International Trade Commission, BGA-packaged product lines and part numbers indicated here currently are not
available from Freescale for import or sale in the United States prior to September 2010: S12XE products in 208 MAPBGA packages
25.4.2.12 Verify Backdoor Access Key Command
The Verify Backdoor Access Key command will only execute if it is enabled by the KEYEN bits in the
FSEC register (see
Table 25-11).
The Verify Backdoor Access Key command releases security if user-
supplied keys match those stored in the Flash security bytes of the Flash configuration field (see
Table 25-
3).
Table 25-55. Verify Backdoor Access Key Command FCCOB Requirements
CCOBIX[2:0]
000
001
010
011
100
0x0C
Key 0
Key 1
Key 2
Key 3
FCCOB Parameters
Not required
Upon clearing CCIF to launch the Verify Backdoor Access Key command, the Memory Controller will
check the FSEC KEYEN bits to verify that this command is enabled. If not enabled, the Memory
Controller sets the ACCERR bit in the FSTAT register and terminates. If the command is enabled, the
Memory Controller compares the key provided in FCCOB to the backdoor comparison key in the Flash
configuration field. If the backdoor keys match, security will be released. If the backdoor keys do not
match, security is not released and all future attempts to execute the Verify Backdoor Access Key
command are aborted (set ACCERR) until a power down reset occurs. The CCIF flag is set after the Verify
Backdoor Access Key operation has completed.
MC9S12XE-Family Reference Manual , Rev. 1.19
Freescale Semiconductor
937
